lacp in x460-24t

[sumeet]

hi ,
i am using X460-24t extreme switch.
here is my setup

mydevice with two links configured in lacp mode --- extreme switch port 3
|
|
extreme switch port4
I have set vlan 3001 on port 3 as tagged with ip 172.16.254.1 . I run ping to it from my device with ip 172.16.254.2 .
I want to set lacp on port 3(master) and 4.
so , I ran
# enable sharing 3 grouping 3,4 algorithm address-based lacp
Question 1) had I used #enable sharing 3 grouping 3,4 lacp , what would be the difference ?
Question 2) Any specific command to see port sharing status ?

[Kevin_Kim]

You can just take out 'lacp' at the end of the sharing command.

# disable sharing 3
# enable sharing 3 grouping 3,4 algorithm address-based

[sumeet]

turns you my device has static LAG support without lacp .
What change should I do in extreme switch setting for this ?

[Erik_Auerswald]

If it works w/o sharing, but stops with sharing enabled (on one side), the other side seems not to use LACP. The "blocked" indicates that the port sharing is not active.

[sumeet]

as soon as I enable sharing .
my ping stops .
I tried
#show vlan3001
got
Ports: 1. (Number of active ports=1) Tag: *3gb
Flags: (*) Active, (!) Disabled, (g) Load Sharing port
(b) Port blocked on the vlan, (m) Mac-Based port

Don't know what blocked indicates ?