multicast streams are freezing randomly on X650
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-19-2014 03:12 PM
i am facing a problem on x650, all multicast streams are freezing randomly for 5-10 sec and then start working again.
Setup:
MC Source ===> Cisco 2960 ====Trunk====> Summit X650 (Stack of 4 Switches) ====> User
Configs:
Extreme X650:
enable ipmcforwarding vlan "ENCODED"
enable ipmcforwarding vlan "GW"
enable pim snooping vlan "GW"
configure igmp snooping vlan "GW" ports 2:1 set join-limit 100
configure pim add vlan "ENCODED" sparse passive
configure pim add vlan "GW" sparse passive
enable pim
configure pim register-checksum-to include-data
Cisco 2960:
ip igmp snooping querier address 10.10.10.9
ip igmp snooping querier
!
Setup:
MC Source ===> Cisco 2960 ====Trunk====> Summit X650 (Stack of 4 Switches) ====> User
Configs:
Extreme X650:
enable ipmcforwarding vlan "ENCODED"
enable ipmcforwarding vlan "GW"
enable pim snooping vlan "GW"
configure igmp snooping vlan "GW" ports 2:1 set join-limit 100
configure pim add vlan "ENCODED" sparse passive
configure pim add vlan "GW" sparse passive
enable pim
configure pim register-checksum-to include-data
Cisco 2960:
ip igmp snooping querier address 10.10.10.9
ip igmp snooping querier
!
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-19-2014 03:27 PM
you could write an acl to count multicast packets[source] hitting x650.
This will be helpful to verify whether x650 is dropping traffic or not.
Example:
entry udpacl {if {
source-address 10.203.134.0/24;
destination-address 239.0.0.100/32;---------change ip based on ur network
protocol udp;
source-port 190;
destination-port 1250;
} then {
permit;
count multicastcounter;
}
}
configure accesslist udpacl ingress
This will be helpful to verify whether x650 is dropping traffic or not.
Example:
entry udpacl {if {
source-address 10.203.134.0/24;
destination-address 239.0.0.100/32;---------change ip based on ur network
protocol udp;
source-port 190;
destination-port 1250;
} then {
permit;
count multicastcounter;
}
}
configure accesslist udpacl ingress
