I found this KB https://extreme-networks.my.site.com/ExtrArticleDetail?an=000087907 but it doesn't really explain why and its quite old. Why can't I see the IP Addresses of clients when using Policy Mode versus whatever else? What other mode can I use, just dynamic VLANs sent back via RADIUS instead of policy names e.g.: tunnel attribute?
------------------------------------------------
Netlogin Clients
------------------------------------------------
MAC IP address Authenticated Type ReAuth-Timer User
aa:aa:aa:bb:bb:bb 0.0.0.0 Yes, Radius MAC 0 aa:aa:aa:bb:bb:bb
bb:bb:bb:aa:aa:aa 0.0.0.0 Yes, Radius MAC 0 bb:bb:bb:aa:aa:aa
-----------------------------------------------
(B) - Client entry Blackholed in FDB
