I am running EXOS VM's in Oracle VirtualBox,I have a topology in this order: R1,R2 and R3. I configured OSPF in one area(0.0.0.0) and all things goes well.But when i tried to make every node in area (R1: area 22.214.171.124 , R2: 126.96.36.199, R3: 0.0.0.0) i could not reach the hole topology
If any of the areas cannot reach your backbone area 0.0.0.0, you can configure a virtual link. This will provide a logical path between the ABR of the disconnected area and the ABR of the normal area that connects to backbone.
The config shots you sent are very confusing. I see that you are creating VLANs which from what I can gather are part of other areas. However I don't see that all 3 of your switches are connected to area 0. In addition I don't see any of the VLANs on the same subnet so they can't talk to one another.
The design should have areas 0 connecting to all three switches on port 1 for example. You can then have a VLAN on each switch that is part of another area. So for example port 2 on Sw 1 can be in area 188.8.131.52 port 2 on switch 3 can be on area 184.108.40.206. If those other ports are connected to another device or the VLAN has loopback on them then those routes for those VLANs should be propagated.