Switch Hang down - All port are disable

[Nucteiv]

Does anyone know what the different settings mean on the Enterasys Captive portal page? I am trying to creat a Guest SSID with authentication, but not sure what some of the settings mean?
What is "Bridge Traffic Locally at HWC" mean? What "Interface IP" are they asking for? The IP of my controller? And what do I put for "VLAN ID"? Is that my wireless vlan?

[Nucteiv]

I have opened a case on GTAC and following the case...

[Stephane_Grosj1]

The GTAC is our Global TAC, our Technical Assistance Center. If you have an issue, hardware or software, you should open a case with them. This may be done by your reseller or yourself directly depending on the contract.

[Nucteiv]

Sory, what is GTAC? I don't understand.

[Stephane_Grosj1]

Hi,

ok, so this is limited to the x440. You should validate you are not exceeding some hardware limits of the x440 here. IP Multicast, ARP...

I don't know if the Multicast table could be (part of) the issue. But this is something you need to address anyway.

When you reboot the x440, you reset every forwarding tables. Over time the x440 only are experiencing issues. I'll start to look at some resources exhaustion.

Have you opened a case with our GTAC on that matter? They should be able to drive you into this troubleshooting.

Best Regards,
Stephane