- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-16-2021 08:18 PM
Hello,
On an X690-48x-2q-4c with EXOS 22.5.1.7-patch1-2, I have configured these commands.
enable sharing 19 grouping 19-20 algorithm address-based L3_L4 lacp
enable sharing 29 grouping 29-30 algorithm address-based L3_L4 lacp
Although the source and destination of the packets are several IP addresses, there is little load balancing.
show ports utilization bandwidth
Port Link Link Rx Peak Rx Tx Peak Tx
State Speed % bandwidth % bandwidth % bandwidth % bandwidth
================================================================================
19 A 10000 37.45 70.98 3.91 5.27
20 A 10000 36.15 79.94 38.07 69.29
29 A 10000 45.78 90.02 2.25 3.80
30 A 10000 44.36 90.43 59.55 100.00
The Tx load is not balanced. May I ask for suggestions to fix this, please?
--- Ambrose.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-23-2021 06:29 PM
Hello
https://extremeportal.force.com/ExtrArticleDetail?an=000062662&q=traffic%20polarization
--- Ambrose.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-23-2021 06:29 PM
Hello
https://extremeportal.force.com/ExtrArticleDetail?an=000062662&q=traffic%20polarization
--- Ambrose.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-22-2021 07:45 PM
Hi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-22-2021 10:41 AM
Hello Miguel,
Thank you for your support. The root cause of the problem is traffic polarisation; there is a KB article on it.
Regards,
Ambrose.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
02-20-2024 04:26 PM
Hey,
How did you resolve it then ?