Hi~
I have a question about using x440-08p.
x440-08p stops powering when I try to connect with POE+ module.
And I could see Port status is “undercurrent fault” in serial port information.
Does “x440-08p” have the under current limit right after powering to POE module?
I think POE+ module consumes little amount of current before POE+ module wake up, So x440 stops powering to POE+ module. Can I adjust the limit?
Or there are another problem for connecting POE+?
I attached some graph below when POE negotiations.
Red line : Voltage from PSE
Blue line : Current
