2016-09-19: New GTAC Knowledge Articles September 11 - 17, 2016

[Ken_Thomas]

Here are the new articles that were published September 11 - September 17 2016 in GTAC Knowledge:

Sunday, September 11, 2016:
none

Monday, September 12, 2016:
OSPF neighbors on either side of a L2 switch, OSPF route updates are lost
Error when enabling SSH on SummitStack
Inventory Manager fails to upgrade EWC firmware
Client reports show packet/data counters 0 and other fields including radio/protocol/rssi as n/a
Active clients show as 1 for every AP in the GUI Config screen
Is it possible to dim the LEDs on an AP?
Extreme Managment Center does not display Wireless Bandwidth
Does Global DHCP Snooping Disable Over-ride Local VLAN DHCP Snooping?
OneView Compass search not finding same results as NetSight Console search
What is the meaning of these log messages Port=XX: Recv own loop back packet from same port

Tuesday, September 13, 2016:
How to add Summit X460-G2 (VIM-2q) to an existing Summit X670-G2 stack using SummitStack-V160
Archive not working, SNMP STACK Timeout errors
Can i factory reset my switch with a script?
AP3620 using DFS channels stuck in scanning after RADAR is detected
How to Clear the Admin Password on the former Enterasys N/S-Series Solution
Video Pixelation is observed when running PIM-Dense on EXOS device
Users logged out with idle timeout message.
Does BD-X8 support FEC (Forward Error Correction) on 100GE interfaces?
What is needed to connect to NAC physical appliance RJ45 COM
K-Series Linecard offline and Logging Buffer displays The offline button on the line card in slot 1 ...
How to create basic ESRP configuration in EXOS
Troubleshooting a NAC/Control Captive Portal not responding to web traffic

Wednesday, September 14, 2016:
I-Series constant reboot with following error in logs "broad_group_xgs3.c(1544)"
What are VxLAN Limitations?
How to Set alerts on DHCPSnooping putting ports in D-Down state
How to create a location for a NAC/Control rule in Netsight Management Center

Thursday, September 15, 2016:
]PoE controller on slot detected hardware port configuration mismatch. Expected 36 found 48+0
Does EXOS have the ZTP+ Cloud Connector included?
7100 - Module restart with Thread Name: tSshM0
Is it possible to have the 10G ports enabled on an ExtremeCloud X440-G2?
Cloud clients are not timing out and showing the incorrect Roles
Switch reboot due to SNMPMaster died with a signal 6
EXOS switch goes in reboot loop when cloud connector is set as preferred image on Netsight
Authentication request become stale in NAC after installation of Microsoft patch kb3172605 or kb3172...
Mac reauthentication enabled on EOS switches does not update the end system events.

Friday, September 16, 2016:
Failed Fan for SSA
How to Configure Spit Tunnel for PPTP on XSR
Do I need to configure mobility in addition to availability when using two controller?
Need modifications in port ID TLV, Device ID TLV sent in CDP messages.

Saturday, September 17, 2016:
none