This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

x450-G2 won't boot after enabling stacking on master

x450-G2 won't boot after enabling stacking on master

Alan_Santoro
New Contributor

‎09-20-2016 04:15 PM

Hey folks!

I'm working on a stack of (3) X450G2-48p-10G4 to replace our old X350 user stack. The new switches have 16.1.0.18 on them from the factory. I enabled stacking and the switches rebooted, but (what should have been) the number 2 switch did not come back up. Consoled into it and found it stuck at:

Copyright 2014 Extreme Networks, Inc.



Starting CRC of Default image

Using Default image ...



Copyright 2014 Extreme Networks, Inc.

I attempted to reboot and get into bootloader a few times, but was not successful. Has anyone seen this before?

0 Kudos
2 REPLIES 2

Drew_C
Valued Contributor III

‎09-29-2016 03:52 PM

Hi Alan, Can you let us know if this issue has been resolved?
0 Kudos

Stephane_Grosj1
Extreme Employee

‎09-20-2016 06:40 PM

Hi,

first of all you should have upgraded, the prompt must have been telling you that: this exos image is not a GA one.

If you cannot go further than that, maybe you can try an upgrade through bootloader. Can you access it? reboot and from console keep pressing the space bar. Don't wait for the message to appear, you might miss it. Try also without stacking cables connected.
GTM-P2G8KFN