hi
when I run a Power-Cycle test
I have Test 301 POE Contact -
FAILED
POE Bad PSE I2C Adrs [0]: FFFFFFFF FFFFFFFF FFFFFFFF
i have updated the poe / harward / software... nothing works
If you have an idea
best regards
If is ERS switch,what is code?
---
Created from this topic:
How do I show the entire configuration without breaks on an Extreme Summit Switch? - similar to using terminal length 0 on Cisco
Being an Extreme XOS engineer, the extreme hardware part numbers as available on the data sheets.
When I look at the 3510 data sheet I can see no ancillary part numbers , fo gbics , stacking cables etc.
Does the avaya hardware accept 10051H ( 1000b...
Is it possible to bind an Standard or Service ACL on the back-side out-of-band Management port on VSP7200 Switch ?
i try to bind a ACL but either i can bind it to an existing VLAN or to an gigabit-ethernet x/y physical port.
Is there a insider tric...
Hello community,
I need your help, does anyone know how Fabric Attach is built between SW's EXOS and VSP 4850?
This without having to use SW's ERS.
Regards,
Cristian
