ExtremeSwitching (VSP/Fabric Engine) - Page 62 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! Re-Route Host Address To Different Next Hop?

Hi,Have the following route map in EOS config that is basically re-routing only the host IP address 10.119.200.158 to a 10.119.0.35 for internet access only.The deny entries are all the internal subnets, which means when going to an internal address ...

Resolved! Powershell VSP enable/disable port

Hello,I search how to configure port (example: enable/disable) on VSP 8400 with Powershell No probleme on X440 (EXOS) with SSHCommand but don’t work on VSP The connection seems good but the orders (Invoke-SSHCommand) are blocked for few seconds, an...

Resolved! Error: SMLT VLAN must have i-sid association.

Hi,Getting the error below but can’t understand what it is requiring me to do:Error: SMLT VLAN must have i-sid association.The VIST is up an running:************************************************************************************ C...

Resolved! segmented management on 5520 running VOSS

Hi, has anybody gotten a 5520 running VOSS and acting as a router with two routed interfaces (VLANs with IPs) to have the segmented management VLAN be accessible from both sides of the router? I created VLANs A and B on the 5520, assigned (public, r...

Resolved! In the VSP7200/7400 series switches, when 10GBASE-T Copper Transceiver is populated at one port, does the adjacent port get disabled?

As in EXOS switches, when 10GBASE-T Copper Transceiver is populated to a port, the very next port (adjacent port) gets disabled.Likewise, Whenever VSP7200/7400 switches (SFP+ compatible models in particular) are populated with 10GBASE-T Copper Transc...

Top Kudoed Authors

User

Count

32

18

16

15

7

GTM-P2G8KFN