MAC-ADDRESS-TABLE... is it posible to see/check in GUI interace?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2019 11:08 AM
This simple question, I know how to do by CLI but I was wondering if it is posible to check via GUI interface.
Regards!
Regards!
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2019 02:36 PM
Yes sure, thank you!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2019 11:15 AM
Yes, you can.
In the ERS under Configuration > Edit > Bridge. Then select the Forwarding tab.
In the VSP under Configuration > VLAN > VLANs. The select the Forwarding tab.
Hope this helps.
Take care,
Steve Dockham
In the ERS under Configuration > Edit > Bridge. Then select the Forwarding tab.
In the VSP under Configuration > VLAN > VLANs. The select the Forwarding tab.
Hope this helps.
Take care,
Steve Dockham
