Adding/configuring access point to controller before they are physically installed
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-18-2017 01:31 PM
Is it possible to add/configure APs prior to them being physically installed. I have a new building going up and we will be installing 40+ APs. I'd like to be able to provision and configure the APs in advance. Is that possible on the C5210 controllers?
Thanks,
-Rich P.
Thanks,
-Rich P.
11 REPLIES 11
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-19-2017 10:21 AM
Don't forget to put settings on default AP !
Especially if the model are not the same ...
Especially if the model are not the same ...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-18-2017 02:06 PM
Please send me email to yostrovs at extreme , I will give you the script with instructions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-18-2017 02:02 PM
Thanks.. this was very helpful.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-18-2017 01:53 PM
Yes as Yury explained. We like to unbox so we can label each AP as well as have the firmware match the controller before taking to a remote building (takes longer on initial boot if firmware doesn't match and bandwidth concerns)...
