cancel
Showing results for 
Search instead for 
Did you mean: 

Adding/configuring access point to controller before they are physically installed

Adding/configuring access point to controller before they are physically installed

Rich_Pacheco
New Contributor III
Is it possible to add/configure APs prior to them being physically installed. I have a new building going up and we will be installing 40+ APs. I'd like to be able to provision and configure the APs in advance. Is that possible on the C5210 controllers?

Thanks,
-Rich P.
11 REPLIES 11

Pascal_Lurquin
New Contributor II
Don't forget to put settings on default AP !

Especially if the model are not the same ...

Ostrovsky__Yury
New Contributor II
Please send me email to yostrovs at extreme , I will give you the script with instructions

Rich_Pacheco
New Contributor III
Thanks.. this was very helpful.

Darin_Seiler
New Contributor
Yes as Yury explained. We like to unbox so we can label each AP as well as have the firmware match the controller before taking to a remote building (takes longer on initial boot if firmware doesn't match and bandwidth concerns)...
GTM-P2G8KFN