AP Scalance W786-2HPW working with Version 9.xx ?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-15-2017 12:22 PM
Hi, is it possible to install a AP Scalance W786-2HPW on controller Version 9.xx ?
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-15-2017 01:02 PM
I believe they are similar, I can try to look to see if the specs are mapped to the same values. As far as how they boot, they would be programmed differently to reflect their specific model number. So you couldn't tell the controller the w786 was a AP3767e for example.
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-15-2017 01:02 PM
Hello Doug, in release notes of 10.31.05.0003 I can see, it will supported "scalance W786C" Does this meen "scalance W786" too?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-15-2017 12:54 PM
thanks for quickly response, is there a difference between a "scalance w786" labled with "Siemens" and a AP3767e labled with "Enterasys"?
Frank
Frank
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-15-2017 12:32 PM
Frank,
It would be listed in the release notes if it was supported.
Regards,
Doug
It would be listed in the release notes if it was supported.
Regards,
Doug
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
