Controller booting in shell prompt every time after reboot
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-03-2015 02:02 PM
We have identifi wireless controllers, one of the controller boots in shell prompt everytime after reboot, which is making the controller interfaces down causing disruption in traffic..... what could be the issue.....
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-03-2015 02:15 PM
Hello,
Take a look at the following to see if it applies....
https://gtacknowledge.extremenetworks.com/articles/Solution/IdentiFi-wireless-controller-does-not-ap...
Take a look at the following to see if it applies....
https://gtacknowledge.extremenetworks.com/articles/Solution/IdentiFi-wireless-controller-does-not-ap...
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-03-2015 02:15 PM
Reference - https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Recover-the-Wireless-Controller-fro...
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-03-2015 02:15 PM
Take a look at the "Recovering the Wireless Controller from File System Corruption" from the Wireless Maintenance guide - https://extranet.extremenetworks.com/downloads/Pages/dms.ashx?download=5ff9760b-ae68-46fd-afbc-ffa87...
If all else fails you should contact the GTAC.
www.extremenetworks.com/support/contact
If all else fails you should contact the GTAC.
www.extremenetworks.com/support/contact
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-03-2015 02:15 PM
Hi the post is not related to my issue..... Controller is booting, but will go into shell mode. The moment I take console to check the status I see my self in shell mode (shell>), once I type exit enter I see a screen with two options 1)boot controller 2rescue ..... It automatically selects 1st one and then it boots perfectly.....
I need to follow the same whenever controller reboots....until the controller boots the interfaces are not coming up.....
I need to follow the same whenever controller reboots....until the controller boots the interfaces are not coming up.....
