DHCP Failover
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-29-2018 09:58 PM
We have a C25 controller on which the primary topology is setup in B@AP mode. We also have 2 - Windows 2012 R2 Domain Controllers with DHCP Server configured on both in DHCP Failover - Hot Standby Mode. When I test the DHCP failover, the PC's on the network failover just fine but anything connected via the wireless does not failover. Any idea's?
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-02-2018 02:41 PM
It should not matter if it's wireless or wired B@AP, the traffic is dropped off to the local switch the ap is plugged into. I would take a trace at the AP and look at the data when the failover is triggered.
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks