How to reset to default factory C25 Controller ?

[el_montro]

How to reset to default factory C25 Controller ?

[Raffi]

If you are not having luck with the serial cable, you could also try the management rj-45 port ( it's the one that is alone, single port ). Try some different serial cables to see if the serial cable is the problem. It should connect with 115200 8-N-1. Try to connect with a normal Ethernet cable, and set your wired nic to 192.168.10.2 255.255.255.0. The management ip by default is 192.168.10.1. ssh to 192.168.10.1, and then you can log in as admin, and use the cli to reset the controller:

EWC.enterasys.com# reset
WARNING: Resetting will clear all configuration except for the management port configuration. It will disconnect any clients currently using the system. Following the reset, the system will be rebooted.
Do you wish to continue? (y/n) n
Reset cancelled by user request.
EWC.enterasys.com#
EWC.enterasys.com# reset ?
Usage: reset [license] [mgmt]
EWC.enterasys.com#

If you have forgotten the admin password, then you will need to access via the serial port, and enter rescue mode to reset the password.

[el_montro]

I guess I should have explained with more detail what I was trying to do 🙂

- How can I access the controller console I tried every different setting but I was unable to ?

- How can I reset the controller from the console ?

[Doug]

Hello,

Please check out the following article....

http://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Reset-an-IdentiFi-Wireless-Controlle...