Identifi - System is not ready
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-15-2015 11:39 AM
Hi, I've deployed several Identifi vms before and I've never encountered this message until now. Whenever I enter the console to log in with the admin - abc123 credentials, it appears a message showing "System is not ready - Please try again". But it doesn't show me this error if I log in with the root - abc123 credentials.
What's the cause of this message? How long should I wait until it's ready?
Thanks in advance.
What's the cause of this message? How long should I wait until it's ready?
Thanks in advance.
6 REPLIES 6
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-15-2015 12:13 PM
Reference: https://gtacknowledge.extremenetworks.com/articles/Solution/Unable-to-start-the-Wireless-Virtual-App...
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-15-2015 12:05 PM
Good news...
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-15-2015 12:03 PM
Yes, it's a virtual controller -V2110- and as I can see, it's was configured to work with 2 cpus. That was the problem.
Thank you all!
Thank you all!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-15-2015 11:52 AM
If controller is hardware based then might be one of the CPU fail of system And if virtual controller then allocate required CPU resources to Vcontroller..
