setting an access point up for site survey
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-03-2015 01:09 AM
Hi I am configuring an Access point for doing my first site survey with extreme access points one of the steps is to Set both radios to a desired channel and max power. Is there a reason why the radios have to be at max power 14dbm will this not lead to issues with over lap
Does anyone have a recommendation or a reason why the radios should be at max power
Thanks for any replies
Does anyone have a recommendation or a reason why the radios should be at max power
Thanks for any replies
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-03-2015 01:30 AM
I will be doing a physical survey moving the ap around the floor to different positions and taking readings with air magnet to make sure I have -67 db coverage on the whole floor
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-03-2015 01:24 AM
Are you verifying measurements based on a predictive plan and need to set the channel and tx power according to the plan or are you just looking for signal propagation based on where the AP is located?
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-03-2015 01:17 AM
I will be using one with a power pack and move it around the floor using air magnet to do the survey
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-03-2015 01:13 AM
How many access points will you be using for the survey?
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks