Single AP with 2 ssid. One works, the other doesn't

[David_Cotos]

Hello all, so I have an Extreme C5210 controller with MULTIPLE ap's. For some reason 3 ap's seem to be acting weird.

I have 2 SSID's running off them. Let's says...ABC (g/n) and XYZ (a/n/ac)

I can connect to ABC just fine, but for some reason I get Limited connectivity with XYZ. I'm not sure why as these signals work just fine through my other ap's.
I did a reboot but that didn't work. Settings appear to be the same across the board for all AP's. I used Inssider and have good signal strength for both ABC and XYZ. Plenty of space in DHCP.

Do you guys have any ideas on what else I should try? I'm at a bit of a loss.

[David_Cotos]

Ahh, you nailed it! Thanks!!

[dcsdne · Accepted solution]

Could it be VLAN tagging on the ports those APs are connected to. I know my different SSIDs all run on different VLANs.