AP 6532 wont adapt to RFS6000

[Perimeterwatch]

I purchased a used AP6532 online. IT just arrived today and I plugged it directly into the RFS 6000 to adapt it and give it the necessary configuration. However, once I plugged it in, nothing new popped up in the controller's GUI. The lights on the AP are flashing both amber and green. How should I proceed to get this operating properly?

Thanks in advance.

[Gavin_May]

There are a few possibilities here but most likely you are running newer code on the RFS-6000 that does not support the AP6532. What version are you running on the controller? You can run the "show ver" command from the CLI to determine this.