AP7522 POE issue

[Michael_Wright]

Please help, today i have being setting up and configuring 10 AP7522s i have got 7 all working correctly but for some reason 3 have POE issues they are constantly rebooting and do not say up. I have changed the cable, directly connected the AP tried different POE config on the switchports but nothing.

The switch is providing POE so all i get is the below:

*Oct 16 10:56:16.747: %ILPOWER-7-DETECT: Interface Fa2/0/23: Power Device detected: IEEE PD
*Oct 16 10:56:17.787: %ILPOWER-5-POWER_GRANTED: Interface Fa2/0/23: Power granted
*Oct 16 10:56:22.435: %LINK-3-UPDOWN: Interface FastEthernet2/0/23, changed state to up
*Oct 16 10:56:24.463: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/23, changed state to up
*Oct 16 10:56:40.723: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/23, changed state to down
*Oct 16 10:56:45.744: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/23, changed state to up
*Oct 16 10:57:01.191: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/23, changed state to down
*Oct 16 10:57:05.926: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/23, changed state to up
*Oct 16 10:58:03.314: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/23, changed state to down
*Oct 16 10:58:04.328: %LINK-3-UPDOWN: Interface FastEthernet2/0/23, changed state to down
*Oct 16 10:58:03.390: %ILPOWER-7-DETECT: Interface Fa2/0/23: Power Device detected: IEEE PD
*Oct 16 10:58:04.396: %ILPOWER-5-POWER_GRANTED: Interface Fa2/0/23: Power granted
*Oct 16 10:58:09.030: %LINK-3-UPDOWN: Interface FastEthernet2/0/23, changed state to up

it just repeats over and over

Please help thanks

[Michael_Wright]

using LLDP I can see a Chassis ID which show an IP address locally obtained by DHCP I can ping the address but i cannot access via SSH.

I have checked adoption history and I cannot see any info for this AP.

[Timo1]

Does the AP get a IP address and can you connect? Check for information via LLDP or CDP.

Do you check the adoption history? Any connection from this AP?

[Michael_Wright]

It doesn't reach the controller, i'm afraid the AP is about 6 hours drive away now so i'm unable to console on to the AP any other suggestions?

[Edmundo]

Can you connect through the console to the APs?

With this we could confirm if it is HW problem

[Michael_Wright]

Please see POE output below:

Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Fa2/0/23 auto on 15.4 Ieee PD 4 15.4

Interface AdminPowerMax AdminConsumption
(Watts) (Watts)
---------- --------------- --------------------

Fa2/0/23 15.4 15.4