Hello community,
I have AP7562i is 3x3 with 3 RF connectors: R1-A,R1-B, R1-C.
When disconnecting the antenna from R1-A connector, but R1-B & R1-C still connected to their connectors - the transmit power is dropped to near 0.
It seems R1-B & R1-C RF connectors are not transmitting at all.
CLI output:
show ver
AP7562 version 5.9.2.5-001R
Copyright (c) 2004-2018 Extreme Networks, Inc. All rights reserved.
Booted from primary
ap7562-xxxxxx uptime is 0 days, 00 hours 03 minutes
CPU is ARMv7, No. of CPUs 2
Base ethernet MAC address is xxxxxxxxxxxxxx
System serial number is xxxxxxxxxxxxxx
Model number is AP-7562-670042-xx
ap7562-xxxxxx#show wi ra de
Radio: 74-67-F7-xx-xx-xx:R1, alias ap7562-xxxxxx:R1
STATE : On
PHY INFO : Bssid: 74-67-F7-xx-xx-xx RF-Mode: 2.4GHz-wlan
ACCESS POINT : Name: ap7562-xxxxxx Location: default Placement: Outdoor
CHANNEL : Current: 1 Configured: smt Width: 20MHz
TRANSMIT POWER : 20 dBm
ANTENNA USAGE : 3x3
MAXIMUM DATA RATES : Phy: 288 Mbps User: 216 Mbps
PHY SETTINGS : Short Preamble: N Dual Channel: N Spectrum Mgmt: N
RATE SELECTION : Standard
ANTENNA DOWNTILT : Not-Supported
RADIO SHARE MODE : Off
TRANSMIT BEAMFORMING : Enabled
MU-MIMO : Not-Supported
SCAN_AHEAD CHANNEL : -
ERP COEXISTENCE : ERP Protection: N Non-ERP detected: N Non-ERP associated: N
HT COEXISTENCE : HT Protection: nonmember mode, Non-HT detected: Y
Current Channel Width: 20Mhz, reason: per configuration
Num of Mcast Streams : 0 (max:25)
Multicast streams :
# MP Mcast Streams : 0
WLAN MAP :
BSS-1 : test123* (*=primary)
Shutdown WLANs :
MESHPOINT map :
BSS MAP :
BSS-1 : basic-rates = 1 2 5.5 11
: supported-rates= 1 2 5.5 6 9 11 12 18 24 36 48 54 mcs-1s mcs-2s mcs-3s
Last error :
Any ideas?
Thanks,
Aviv Kedem
