cancel
Showing results for 
Search instead for 
Did you mean: 

cluster config update rejected

cluster config update rejected

Jose_LV
New Contributor III
Hello
I have a cluster with 2 rfs 6000. Since yesterday, this event appears:
Err: cluster config update rejected - master does not accept full config.
And any configuration made in the active rfs is not replicated in the standby rfs
6 REPLIES 6

Jose_LV
New Contributor III
Solved
Turning off and starting the controllers in order, first the active controller and then the standby controller, the cluster has been configured ok and the error has disappeared. The simplest solution at the end is the most effective.
Thanks everyone
Regards.

Timo1
New Contributor II
Hi,
do you have configured different priority? If you don't configure this and have new configuration on booth sides, that can be the problem.

Jose_LV
New Contributor III
Hi Timo
The priorities are configured with different values in the two rfs.
The rfs and the cluster were working well for a long time until the restart that was made yesterday.

the show cluster member command shows the two rfs and the show cluster status command shows one rfs in active and another in stanby in the cluster

Daniel_Mejia
Extreme Employee
Hi Jose,

Please reference the following KCS article on WiNG cluster configuration.

How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above
GTM-P2G8KFN