I cant access my ap 7255 from GUI after configuring new vlan
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
06-06-2019 06:10 PM
I can’t access my AP 7255 controller since I have created a new vlan. All the other access point which were connected and had static IP are now taking IP through dhcp and I cannot access my controller and can’t ping it either.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
06-06-2019 06:18 PM
Hello Sushant,
You will need to access the VC AP via console (baud 115200 and all other settings default) and after login, review the running-config and verify setting are valid:
enable [enter]
show run [enter]
If the APs are under contract entitlement, you may want to call our support center at 800-872-8440 and get a support case generated for assistance.
You will need to access the VC AP via console (baud 115200 and all other settings default) and after login, review the running-config and verify setting are valid:
enable [enter]
show run [enter]
If the APs are under contract entitlement, you may want to call our support center at 800-872-8440 and get a support case generated for assistance.