Need help with a tutorial or some direction on setting up new AP7662 units

[Brett_Morrison]

Hi guys

Been a while since I have setup Zebra/Extreme APs, and I have just purchased 4 new Extreme AP7662 units for use at one of our sites. I have set one up as a controller, with the usual settings, plugged in another which adopted the settings. Once I change the name of the new unit and restart, it seems to go out on it's own instead of being part of the management group. this has now happened with the additional 3 APs, so I am not sure what I am doing wrong. They also seem to only be adopting one WLAN/SSID from the VC.

I am sure there is something I am missing, is there a tutorial on how to set these up with the new WiNG v5.9 ?

thanks.

[Brett_Morrison]

All good thanks, working through the VC quick start now.

[Steven_Lin]

Could you please try it from CLI below?
From a Console connection, login with the following credentials:
Username: reset
Password: FactoryDefault

[Brett_Morrison]

Hi all, thanks for the input, I'll take a look and see how I go.

Brett

[Steven_Lin]

Hi Brett,
Here is Wing5 Virtual controller quick start guide for your reference
http://documentation.extremenetworks.com/WiNG/Implementation_Guides/HeterogenuousVirtualController-Q...

[Ondrej_Lepa]

Hi Brett,

If you need a training, check Training & Certification - https://www.extremenetworks.com/education/courses/ECS-WiNG-1/ on Extremen Net. portal.

If you a just need some materials to refresh your experience, check ExtremeWireless WiING Software Reference guides under documentation.

As mentioned by Mevan, all chances must be saved using "Commit Save" (GUI) or "commit write" (CLI)
This prints the running config into startup one.

Regards,
Ondrej