cancel
Showing results for 
Search instead for 
Did you mean: 

Wing express AP 7502 initial configuration

Wing express AP 7502 initial configuration

Niyas
New Contributor III
Hi Team,

Actually, I am doing initial configuration with individual AP and PC without a controller,

So, what are the steps needed to configure AP without a controller, only IP setting?

Regards

NIyas P

3 REPLIES 3

Christopher_Fra
Extreme Employee
If running WiNG v5.9 on Express AP, the following link is the latest Express User Guide for v5.9.x:

https://documentation.extremenetworks.com/WiNG/5.9.0/9035125_WiNG_Express_5_9_UG.pdf

Christina_M
Extreme Employee
Hi there,

Here's the Quick Reference Card for this AP: https://documentation.extremenetworks.com/ExtremeWireless/AP7502_WALLPLATE_IG_MN001385A01_REVD_EN.pd...

The relevant section is Basic Ap-7502 Configuration:
To provide the Access Point with a basic configuration and access WiNG management functions, open a browser and enter the IP address printed on the serial label on the Access Point: https://.

Log in to the system using the default username (admin) and password (admin123).
1. On the Configuration -> Basic Settings screen, enter the AP Name and Country Name.2. On the Configuration -> Wireless screen, enter the desired Name, SSID, Security, and WPA2 Key parameters.

Also, here's the latest WiNG Express User Guide. AP Configuration starts on page 9: https://documentation.extremenetworks.com/ExtremeWireless/WING_EXPRESS_5.8_UG_MN002231A01_EN.pdf

Hope that helps!

aholden
Extreme Employee
Hi

The initial step will be lo log into the WEB INTERFACE.

The APs ge1 port is configured as an ACCESS port utilizing DHCP to obtain an I/P

Wing Express does not allow CLI configuration updates.

Once you are in the AP, you can then set it to a Static I/P

Depending on the release, there is a configuration guide that will lead you through a basic configuration

GTM-P2G8KFN