FAQs - Page 48 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

Sample VRRP Configuration for the C3/C2/G-Series

Article ID: 12335 Products SecureStack C3, all firmware SecureStack C2, firmware 3.00.50 and higher G-Series, all firmware Goals VRRP sample configuration. Solution The following configurations sets up two routers configured to back each other ...

ACLs can block IP Based Multicast Protocols

Article ID: 5775 Protocols/Features ACL VRRP HSRP BGP OSPF RIP PIM DVMRP IGMP Symptoms ACL unexpectedly blocks the operation of IP based multicast protocols Keep-alives are filtered Advertisements are filtered Cause When implementing IP-specifi...

S/N/K-Series f/w 7.31.03.0010 "Sender Hardware Address does not match L2 source address" Syslog message

Article ID: 14395 Products S-Series, firmware 7.21.03.0003 and higher Matrix N-Series DFE, firmware 7.21.03.0003 and higher K-Series, all firmware Symptoms The Router Arp Process reports a MAC address mismatch in Syslog. Here are Multicast and ...

N-Series Unicast-as-Multicast Sample Configuration

Article ID: 10906 Products Matrix N-Series DFE Changes Installed Load Sharing server software (e.g. NLB), or similar application that uses the same MAC address on multiple network adapters. Configured SNMP Traps (5390). Globally and port enabled...

Using S/K-Series Policy to identify IPv6 Router Advertisements

Article ID: 14443 Products S-Series K-Series Goals Identify IPv6 Router Advertisements on user ports, for the purpose of dropping what amounts to "rogue" IPv6 traffic that can either directly misroute IPv6 traffic or cause IPv6/IPv4 users to try ...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN