FAQs - Page 50 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

K-Series 'set ssh enabled' command is Lost upon 7.31.04 to 8.02.01 Upgrade

Article ID: 15069 Products K-Series; firmware 7.31.02.0008, 7.31.03.0010, 7.31.04.0002 Changes Enabled SSH access to system management ('set ssh enabled'). Then, upgraded firmware from 7.31.04.0002 (or lower) to 8.02.01.0012, and rebooted onto it...

S/N/K-Series 'debug ip bgp update' output does not match EBGP Peer Updates

Article ID: 14823 Products S-Series, firmware 8.02.01.0012 and lower Matrix N-Series DFE, firmware 6.01.01.0020 and higher K-Series, firmware 8.02.01.0012 and lower Changes From the router configuration CLI, issued the 'debug ip bgp update' comma...

K-Series logs "Received Interrupt PETRA_QDR_ECC" messages

Article ID: 14274 Products K-series, firmware 8.02.01.0012 and lower Symptoms Hardware interrupt message "Received Interrupt PETRA_QDR_ECC" appears on local console and in syslog ('show support'), but not in the debug messageLog ('show support')....

D-Series f/w 6.03.10.0003 erroneously reports Fan Failure error

Article ID: 14536 Products D-Series, firmware 6.03.10.0003 and lower D2G124-12, D2G124-12P Symptoms Fan Failure messages and traps are sent to the console, logs, and network management; for example: code:Jan 5 08:00:47 172.16.21.201-1 SIM[6745162...

D-Series Fan Behavior expectations

Article ID: 14554 Products D-Series D2G124-12, D2G124-12P Goals When do the switch cooling fans run? In the output of a 'show system', does a Fan1-Status or Fan2-Statusof "Not Installed and/or Not Operating" mean that a fan has failed? Solution...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN