FAQs - Page 78 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

N-Series v7.x does not support the classic Ratelimit command set

Article ID: 13816 Products Matrix N-Series DFE, firmware 7.11.01.0025 and higher Changes While running firmware 6.12.08.0003 or lower, configured rate-limiting using the 'set port ratelimit...' command set (7345). Then, upgraded to firmware 7.11....

Inbound Rate Limiting is Overly Restrictive to TCP/IP

Article ID: 11667 Products Matrix N-Series DFE Changes Configured a Role-Based Inbound Rate Limiter (7537 ,'set cos...', 'set policy...'). -or- Configured a Priority-Based Inbound Rate Limiter (7345, 'set port ratelimit...'). Symptoms A sni...

Developing a PPS inbound rate limit for N-Series

Article ID: 7537 Products Matrix N-Series DFE Goals Inbound Rate Limiting (IRL) to a maximum number of Packets Per Second (PPS). Sample configuration for rate limit at 100 PPS. Solution This configuration uses an LLC frame as an example of a pa...

Disabling Ports using Inbound Rate Limiters on the N-Series

Article ID: 11731 Products Matrix N-Series DFE Goals This document provides a sample configuration using packets per second rate limiting to trigger a port disable. A policy-rule-based action will disable on the first packet seen, but this policy...

Configuring Rate Limiting on the N-Series DFE

Article ID: 7345 Products Matrix N-Series DFE, firmware 6.12.08.0003 and lower Goals Configure rate limiting. Sample configuration. Symptoms 'set port ratelimit' Solution As described in the Matrix DFE Configuration Guide, the ratelimit comma...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN