FAQs - Page 84 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

Back-Rev Firmware on a SecureStack

Article ID: 9687 Products SecureStacks B2-series, B3-series, C2-series, C3-series, A2-series Goals Provide the commands and reasoning that allow a SecureStack to go backwards in the firmware it will execute. The SecureStack has no issue when upg...

SecureStack Reboot Loop After a Back-Rev to Older Firmware

Article ID: 9673 Products SecureStack B2, B3, C2, C3 Symptoms SecureStack is in a constant reboot mode after downloading an image that is older than what was previously in use. Cause The older image can not read the configuration files that are...

S-Series / 7.x Default State changes

Article ID: 12516 Products S-Series, firmware 7.x Matrix N-Series DFE, firmware 7.x Solution As a change from N-Series 6.x firmware, in 7.x firmware the following protocols have been disabled by default at the port level:LACP - To enable on all p...

N-Series Static LAG not working after Upgrading to 7.x Firmware

Article ID: 13678 Products Matrix N-Series DFE, firmware 7.11.01.0025 and higher Changes Configured a Static LAG ('set lacp static...'). Globally disabled LACP ('set lacp disable'). Symptoms The Static LAG works fine with older firmware, until ...

What is Flow Setup Throttling?

Article ID: 5289 Protocols/Features Flow Setup Throttling FST Solution Flow Setup Throttling is a software feature which increases network security and reliability. The FST processes are controlled and monitored by means of the enterasys-flow-l...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN