Article ID: 5847
Products
SecureStack B2
Firmware 3.01.27 and lower
SecureStack A2
Firmware 1.03.24 and lower
Protocols/Features
Diffserv
Symptoms
Diffserv value does not appear in the config
Diffserv error upon activation of saved configuration
'set diffserv'
'show config'
Cause
Certain non-default diffserv values used in the commands 'set diffserv policy action conform markprec', 'set diffserv policy police action conform', and 'set diffserv class match cos' (
5848) are accepted and implemented but then are not displayed in the output of a 'show config' command.
Then, offloading and reloading the affected config (
5623) results in a cli error due to the presence of an incomplete command.
Solution
For the B2, upgrade to firmware 4.00.22 or higher.
For the A2, upgrade to firmware 1.04.12 or higher.
Pre-upgrade workarounds:
- After configuration, any missing parameters may be viewed by issuing the relevant 'show diffserv...' command.
- After booting onto a problematic configuration file, any missing parameters are not retrievable. Replace any errored command by retyping the original full command.
