cancel
Showing results for 
Search instead for 
Did you mean: 

RFS6000 with image WinG7.3.0

RFS6000 with image WinG7.3.0

emery0123
New Contributor

Hi there,

I have an rfs6000 controller that runs withAP7161 and AP7562 APs, I want to do a hardware upgrade to AP460e-WR while keeping the same controller RFS6000 and do a firmware upgrade from WinG5.8 to WinG7.3.0 (required firmware for AP460e-WR). 

  • Is that firmware upgrade possible on rfs6000?
  • if yes, would AP7161 and AP7562 still adopt to rfs6000 with this new firmware and work normally (in mesh) with AP460e ?

Thanks in advance!

1 ACCEPTED SOLUTION

Tomasz
Valued Contributor II

Hi,

 

Please review the release notes here: https://www.extremenetworks.com/support/documentation/extremewireless-wing-software-7-3-0/ you can pick different versions from that dropdown menu on the right.

RFS 6000 is EoL for a long time. As far as I remember 5.9.1 was the last release that is available for it. Unfortunately, that means RFS 6000 can’t be a controller for AP460e.

 

Hope that helps,

Tomasz

View solution in original post

3 REPLIES 3

emery0123
New Contributor

Thanks for the feedback, I guess I came to the same conclusion too!

Tomasz
Valued Contributor II

Hi,

 

Please review the release notes here: https://www.extremenetworks.com/support/documentation/extremewireless-wing-software-7-3-0/ you can pick different versions from that dropdown menu on the right.

RFS 6000 is EoL for a long time. As far as I remember 5.9.1 was the last release that is available for it. Unfortunately, that means RFS 6000 can’t be a controller for AP460e.

 

Hope that helps,

Tomasz

emery0123
New Contributor

Any feedback would be appreciated!

GTM-P2G8KFN