Scripting - Page 3 - Extreme Networks

Scripting

Questions and discussions about scripting

Forum Posts

Sorted by:

Start a conversation

Create a workflow that runs a script to a port based on port displayname

Hi,Wondering if anyone has a script that can run on EXOS switches to look for a certain name configured on a port (display port name), and then when found, it will run on that port some cli commands.For example, if I have a port 1:40, with name "WAN"...

Create file with sysName in filename using Python

Hello all,I recently started using Netmiko with Python to script out data collection on EXOS/VOSS switches, and I am trying to export the outputs of commands to a file using the switch name as well as the command that was ran. The script is working, ...

XMC Governance regex flags

Hi, I'm trying to catch a especific config for a interface vlan, but since there are several interfaces vlan I'm getting a no match. for example: ! interface vlan 321 ip igmp snoop interface vlan 124 ip igmp snoop ! I'm trying the following expre...

Add wait time to xsf file

Hello Everyone,I'm trying to automate a simple task of turning some port up/down with a script. Where I'm getting stuck is when I try add a pause. This is what I have:show port 12 configuration no-refreshdisable port 12#timer 1enable port 12show port...

Add route to VRF

Hi ExpertsI'm quite new in this.I ned to add a static to a vrf in our VSP8284XSQ Switch.When a do a : sh ip route vrf MYVRF i got thisDST MASK NEXT VRF/ISID COST FACE PROT AGE TYPE PRF172.22.0.0 255.255.0.0 172.16.1.1...

Top Kudoed Authors

User

Count

3

2

1

1

1

GTM-P2G8KFN