Using EDP output in scripting

[Davor]

I would like to use sh edp ports all in script to indentify trunk ports.
Created script, loaded it and got error in that line. Is there some limitation to this?

"
...

set var CLI.OUT " "
show edp ports all
set var inputA $TCL(list ${CLI.OUT})
set var listA $TCL(split $inputA "\n")
set var countA $TCL(llength $listA)

....

"

BR
Davor

[Paul_Russo]

Hey Davor

what are you trying to get out of the script?

the above looks like you are trying to get the MAC address or something

Thanks
P

[Davor]

Hello,
I'm struggling with regxp that will read out output from “sh edp”. Currently using {(?![0-9:]+\s+)([A-Za-z0-9._+-]+\s+)([0-9:]+\s+)([0-9:]+\s+)([0-9]+\s+)([0-9]+\s+)}.
Could you help me defining how should regxp for reading out "sh edp ports all" output look like.

BR
Davor

[Paul_Russo]

Hey Devor

I ran it again using my VM image in a virtual lab and here's the output running it as a script. I have the show var commands still in there to show what is in each var statement.

Summit-PC.1 # tftp 192.168.56.1 -v vr-m -g -r testscript.xsf
Downloading testscript.xsf on primary Node ... done!
Summit-PC.2 # load script testscript
{
Port Neighbor Neighbor-ID Remote Age Num
Port Vlans
=============================================================================
2 Summit-PC 00:00:08:00:27:57:b0:6a 1:2 41 1
=============================================================================
}
\{ {Port Neighbor Neighbor-ID Remote Age Num} { Port Vlans} ============================================================================= {2 Summit-PC 00:00:08:00:27:57:b0:6a 1:2 41 1 } ============================================================================= \}
7
Summit-PC.3 #

[Paul_Russo]

Hey Devor I tried this and it worked for me. Here's the output of running the script I added show statement to show what the var are. Unfortunately I did this on my VM so I didn't have any data. Summit-PC.18 # enable cli scripting Summit-PC.19 # enable cli scripting Summit-PC.20 # set var CLI.OUT " " Summit-PC.21 # show edp ports all Port Neighbor Neighbor-ID Remote Age Num Port Vlans ============================================================================= Summit-PC.22 # set var inputA $TCL(list ${CLI.OUT}) Summit-PC.23 # set var listA $TCL(split $inputA "\n") Summit-PC.24 # set var countA $TCL(llength $listA) Summit-PC.25 # show var inputA { Port Neighbor Neighbor-ID Remote Age Num Port Vlans ============================================================================= } Summit-PC.26 # show var listA \{ {Port Neighbor Neighbor-ID Remote Age Num} { Port Vlans} ============================================================================= \} Summit-PC.27 # show var countA 5 Summit-PC.28 # Please let me know what your output is when you run this Thanks P