your examples are fine. so 1/1 and 1/2 have tagging disabled, which means these are access (not trunk) ports.Port 1/3 has encapsulation dot1q enabled, so is in trunk mode.regarding PVID: if a trunk was never attached to any VLAN, the PVID is just 0. ...
not sure, if this i really a limitation, but i would check, whether configuring a CLIP /loopback address in the corresponding VRF would help.We recommend this anyway, as with ONE-IP ICMP would not work without a dedicated CLIP per VRF (in case of GRT...
this sounds a bit weared to me...First of all: VLACP is a feature, which is only supported on VOSS/FabricEngine OS. DO NOT use it for connections to EXOS or any other switches!For LACP-based connection there is not much to configure. If your VIST bet...
In VOSS / FabricEngine OS there is two command,s that would do the job: show vlan mac-address-entry [mac | port | <vid>] orshow i-sid mac-address-entry [<isid> | mac | port | non-local | home | remote]one of the good things about using fabric is se...
BTW: i am seeing the same message as you also on any switch, that already has a saved config, so ZTP+ is not active.Verify using this command:C2:1(config-app)#% show application auto-provision==========================================================...
