cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

ACL policy to restrict telnet is not working as desirable

ACL policy to restrict telnet is not working as desirable

Francisco_LeitĆ£
New Contributor
I'm new using extreme switches. I have configured the following ACL policy to allow only the networks listed in the policy to connect by telnet to the switch model X480-24X, running ExtremeXOS version 15.6.4.2, however only the host with IP address 200.20.76.42 is connecting the others are being rejected.
Has anyone ever faced this problem?

Entry AllowTheseSubnets {
if match any{
source-address 200.20.76.42 /32;
source-address 187.111.111.5 /32;
source-address 200.20.66.176 /27;
}
then
{
permit ;
}
}

Tks in advance

6 REPLIES 6

Francisco_LeitĆ£
New Contributor
I hadn't done that! To be honest I had no idea this command was required when you change an ACL. After issuing the refresh command the ACL worked fine!

As I had told I am new in Extreme switches.

Tks!

No problem, we are here to help. Welcome by the way.

StephenW
Extreme Employee
did you refresh the policy?

Francisco_LeitĆ£
New Contributor
Hi Stephen,

First of all thanks for your attention,

I have configured the ACL as you suggested, even so, It's not working. Following you can see the message in the log informing the connection has been rejected.

SW-IPLAN.5 # show log
05/03/2018 15:21:28.59 Telnet connection from source 187.111.111.5 has been denied by access-list IplanAcesso. Rejecting connection.

Tks!

GTM-P2G8KFN