Creating a toplogy for end users

  • 0
  • 1
  • Question
  • Updated 3 years ago
  • Answered
I want end users to get ip address (from dhcp server) from the ssid i have created.

what all toplogies have to be created (planning for B@AP).

what tagging/untagging has to be done on
1) controller?
2) the switch port on which controller will be connecting?
3) on the switches to witch ap's get connected.
Photo of Saiprasad Rao Rapolu

Posted 3 years ago

  • 0
  • 1
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 51,458 Points 50k badge 2x thumb
Hi, would you please be so kind and not create different posts to the same issue.

Everything was discussed in your other one....

I don't want to be rude but I'd STRONGLY recommend to get someone onsite to support you.

It's not easy to design a network that big (from the information that you've provided so far) in a forum post without previous experience and a full unterstanding how the solution works.

Kind regards,
Photo of Doug Hyde

Doug Hyde, Technical Support Manager

  • 20,710 Points 20k badge 2x thumb

Have you taken a look at our "Wireless Getting Started
Guide"?  It should help point you in the right direction.
Photo of Karthikeyan M

Karthikeyan M, Systems Engineer

  • 546 Points 500 badge 2x thumb
I recommend the suggestions from Doug and Ron. The queries above are network level decisions and are not just controller configs. I would suggest make these design decisions with help of Partner. 

For the above question : Assuming that VNS NonAuth topology traffic is B@AP, DHCP Server is in DMZ VLAN, Clients placed in Wireless VLAN, you can configure bootprelay in Extreme switches. Follow below link for more info :

Since you are planning for B@AP you need to tag client VLANs in EWC, but needed to switchport connected to AP. In controller you need to configure B@AP topologies that will be pushed to APs.