AP250

[prabhat]

Hi,

?

I have four Aerohive AP250 on my network. One of the access point fails and i got replacement from vendor. Now when i am connecting access point in my network in same switchport where previous AP was connected, the new AP is not getting ip from DHCP. I have tried command int mgt0 dhcp-probe vlan-range (native vlan).

But still it is not getting IP. After i tried to assign mgt0 interface with manual IP. Strange this is that i can ping AP ip but when i restart device AP ip is not reachable. However ip is same what i have assigned manually.( Show interface mgt0.

?

When i see switchport in my cisco switch light is not blinking. It means it is providing PoE only i guess.

?

Is there anything which i am missing in AP as all of other AP is working fine.

?

Thanks

Prabhat?

?

[prabhat]

Hi,

When i am connecting AP in existing working AP250 switchport, from console i am getting ip like 192.168.1.1 255.255.0.0.

But it is not taking IP from DHCP. After several tries i will reset device 2-3 time than it will take hardly onetime and after restart again same issue.

[ashley_finch]

If you connect the AP to one of the known working ports, does it then get an IP address by itself? Is the port configuration on the switch different at all?