10-09-2018 12:51 PM
There is a complete lack of instruction on how to install the ATOM AP30's. The videos show a complete config free deployment, literally plug and play. But nowhere does it give you details on the pre-requisites. I'm still having problems now. Whilst I wait for support from our reseller, does anyone have a full breakdown of what's required?
Videos and a webinar seemed to suggest it's literally take it out and plug it in. But I can't get anything useful from the device at the moment.
I ended up creating an auto provisioning policy, and used the on boarding on HiveManager NG. But I still can't connect to the ATOM, and it repeatedly fails to update when I try and change hostname. Any quick assistance much appreciated.
It's connecting to an AP250 (mesh) which has had backhauling mesh enabled on a radio.
Solved! Go to Solution.
10-09-2018 03:10 PM
We do have some guides to help with ATOM deployment:
A guide to help connect the device (and the pre-requisites prior to plugging the device in)- https://thehivecommunity.aerohive.com/s/article/ATOM-CAPWAP
A guide to help troubleshoot problems getting the ATOM connected if you've done everything in the first guide but are still having issues- https://thehivecommunity.aerohive.com/s/article/ATOM-Troubleshooting
If you're still having problems, please let me know and I will do my best to troubleshoot with you here.
10-10-2018 03:45 PM
10-10-2018 10:01 AM
BJ - thanks for the info. I saw that in the documents and our AP's are all updated so that's one less thing to get in the way.
Sam - I've unboxed all 3 ATOMS and installed them around the floor, in proximity to different APs. The AP250 devices all have meshing enabled on both radios now.
I add the serial numbers (quick add) and then wait.
After quite some time (15 minutes plus) the devices showed up with a green tick.
I connect a device or two in close proximity to the Atoms, and no devices show as connected. They are connecting to the AP250's (in range, but weak signal, hence the ATOMs).
If I change the hostname on the ATOMs, and Save and Update, the ATOM is broken. The AP shows red status, stuck on 29% updating in progress. Been like that for half an hour or more.
Thanks in advance, Alan
10-09-2018 03:38 PM
Many thanks Sam. I am going to take another one out the box tomorrow and try that, I suspect we may have a faulty first unit, as it's been provisioned, then dropped off, then been reset and re-appeared, but at no point am I seeing any client connections on the device. Appreciate you watching out for the replies anyway, thanks.
10-09-2018 03:35 PM
When we first attempted an installation, we were unaware that the meshed APs required HiveOS 8.4 or better for the hands free deployment. We were using AP350s upstream which only run 6.5. Hope this helps.
Best,
BJ
10-09-2018 03:10 PM
We do have some guides to help with ATOM deployment:
A guide to help connect the device (and the pre-requisites prior to plugging the device in)- https://thehivecommunity.aerohive.com/s/article/ATOM-CAPWAP
A guide to help troubleshoot problems getting the ATOM connected if you've done everything in the first guide but are still having issues- https://thehivecommunity.aerohive.com/s/article/ATOM-Troubleshooting
If you're still having problems, please let me know and I will do my best to troubleshoot with you here.