AP630 firmware version 10.3 capwap disappears over and over Agin. The settings will disappear from the config within a min of adding and saving ... I have reset unit and tried to roll back firmware. Always removes capwap settings.
AH-2ab2c0#show capwap client
CAPWAP client: Enabled
CAPWAP transport mode: UDP
DISCOVERY state: Sending Discovery packets to find the CAPWAP server
CAPWAP client IP: 192.168.3.156
CAPWAP server IP: 0.0.0.0
HiveManager Primary Name:
HiveManager Backup Name:
CAPWAP Default Server Name: hive.xxx.xxx
Virtual HiveManager Name: home
Server destination Port: 12222
CAPWAP send event: Enabled
CAPWAP DTLS state: Enabled
CAPWAP DTLS negotiation: Enabled
DTLS next connect status: Enable
DTLS always accept bootstrap passphrase: Enabled
DTLS session status: Disconnect
DTLS key type: passphrase
DTLS session cut interval: 5 seconds
DTLS handshake wait interval: 60 seconds
DTLS Max retry count: 3
DTLS authorize failed: 0
DTLS reconnect count: 0
Discovery interval: 5 seconds
Heartbeat interval: 30 seconds
Max discovery interval: 10 seconds
Neighbor dead interval:105 seconds
Silent interval: 15 seconds
Wait join interval: 60 seconds
Discovery count: 2
Max discovery count: 3
Retransmit count: 0
Max retransmit count: 2
Primary server tries: 0
Backup server tries: 0
Keepalives lost/sent: 0/61
Event packet drop due to buffer shortage: 0
Event packet drop due to loss connection: 3
debug says
CAPWAP can not find the proper request 6007, Maybe HM doesn't support it.
