Brocade Switch and AP550 agr0 ?! LACP dynamic not working

[fab]

Hello ,

I am configuring 50 AP550. But we are unable to get the aggr0 working.

Do we have to configure the switch with LACP or not? Or static LACP?

Can someone explain me if we need to adjust the ports as LAG or does the AP550 manage it?

The aggregation of AP550 is it dynamic or static or none of them? I could not find any specification in the datasheet.

Best, Fab

[samantha_lynn]

The AP running the LACP is active, the switch will be passive. You do need to aggregate the ports on both sides, to do this on the AP side you would want to set this via the device template you assign to the AP 550. Select both ports> Assign> Advanced Actions> Aggregate.