Extreme Networks

AnonymousM · ‎08-20-2019

Can please someone provide the commands needed to configure Secure Port Settings via Supplemental CLI in Hivemanager NG?

s_heise · ‎10-23-2019

Probably our support got a feedback from Aerohive with the commands that where already mentioned in this feed.

I got the information that you will be unable to enter a password for the supplicant, but with the right firmware it is possible.

For AP141 it doesn't work as the commands doesn't exist there and also the configuration isn't supported as it is done by CLI only.

@Sam Pirok is it possible that you start a feature request for this, as it was already possible to configure it on the Hivemanager Classic Cloud GUI, so this configuration will be supported again?

View solution in original post

reinhardg · ‎10-11-2019

Hello Sebastian,

we have HiveOS V8.2r6. Are you sure that this worked with HM classic and AP141 with 6.5r12? (I had a look into the latest CLI-guide for AP141 and didn't find anything usefull. However, it's for V6.5r11.)

s_heise · ‎10-11-2019

Hello Gunter,

thank you for the feedback, unfortunately I don't have the command supplicant.

Which firmware are you using?

We have 6.5r12 on the AP141.

Best regards,

Sebastian

reinhardg · ‎10-11-2019

Probably the commands are:

supplicant name_of_supplicant

supplicant name_of_supplicant username username password ***

interface eth0 supplicant name_of_supplicant

interface eth1 supplicant name_of_supplicant

I looked into an APs config created with HM classic. With HM (NG) I didn't find the settings, too.

AnonymousM · ‎08-21-2019

I don't think this is the right feature, as I have to assign a Radius server, which is normally not needed. Also this feature is only available when the port is used as an access port, but for me it has to stay as uplink port.

Attached you can find a screenshot of the settings I had to set in the Hivemanager classic, I hope this helps.

samantha_lynn · ‎08-20-2019

If you go to Configure> Open the Network Policy> Go to the Device Templates tab within the Network Policy> Go to the Switch Templates sub-tab> Port configuration (left hand side menu)> Select a port> Assign> Create New> Scroll down and go to the Wired Connectivity sub-tab> Toggle User Authentication to ON, these should be equivalent settings for a secure port in HiveManager NG. Is that what you're looking for?