This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Can please someone provide the commands needed to configure Secure Port Settings via Supplemental CLI in Hivemanager NG?

Can please someone provide the commands needed to configure Secure Port Settings via Supplemental CLI in Hivemanager NG?

Go to solution
AnonymousM
Valued Contributor II

‎08-20-2019 07:05 AM

Can please someone provide the commands needed to configure Secure Port Settings via Supplemental CLI in Hivemanager NG?
0 Kudos
1 ACCEPTED SOLUTION

Go to solution
s_heise
New Contributor II

‎10-23-2019 05:31 AM

Probably our support got a feedback from Aerohive with the commands that where already mentioned in this feed.

I got the information that you will be unable to enter a password for the supplicant, but with the right firmware it is possible.

For AP141 it doesn't work as the commands doesn't exist there and also the configuration isn't supported as it is done by CLI only.

 

@Sam Pirok​  is it possible that you start a feature request for this, as it was already possible to configure it on the Hivemanager Classic Cloud GUI, so this configuration will be supported again?

View solution in original post

0 Kudos
26 REPLIES 26

Go to solution
s_heise
New Contributor II

‎10-15-2019 12:34 PM

That's true, Aerohive doesn't provide a statement on this post, on my case with our distributor and also not in direct contact.

At least they should know it better...

0 Kudos

Go to solution
reinhardg
Contributor II

‎10-15-2019 08:41 AM

In the CLI-guide of for example AP130 and version 6.6r1 I found the "supplicant" command. So it looks like this command was introduced with that version. I'm sorry, but I have no idea how to configure 802.1x port security with the older versions. I wonder why no one from Aerohive gives a statement to this.

0 Kudos

Go to solution
s_heise
New Contributor II

‎10-14-2019 12:52 PM

Most of the devices are AP141, we have only 4 other types. These have the firmware 10. and there I can find the CLI command.

Regarding the authentication I could see that the AP141 is authenticating, as they can be identified by IP and MAC.

0 Kudos

Go to solution
reinhardg
Contributor II

‎10-14-2019 10:40 AM

That's indeed curious. Are all of your APs of type AP141? Maybe you have seen the auth of another AP on your Cisco ISE?

0 Kudos

Go to solution
s_heise
New Contributor II

‎10-14-2019 08:31 AM

Hello Gunter,

 

I am sure it worked, as I had proper authentication of the APs on the Cisco ISE with the username configured over the HM Classic.

That's why I am curious, that there are no CLI commands for this settings and that I wasn't able to see it in the configuration.

 

Best regards,

Sebastian

0 Kudos
GTM-P2G8KFN