04-03-2019 02:43 PM
This should be very simple, but if I want to hard wire an ATOM instead of use the wireless mesh, shouldn't plugging it in be enough? Won't it automatically use the wired interface instead of meshing?
04-04-2019 11:35 AM
04-04-2019 09:40 AM
Annoyingly, the switch is all configured correctly, in fact an AP250 works off the same cable to prove it's working. The ATOM is not having it at all though. The template has the Ethernet setup and enabled as an uplink. But the HM shows it as disabled when you check the status. I wonder if it's broken in fact, never checked with a cable. I will have to wipe it I think and re-provision to see...
04-03-2019 05:01 PM
If the upstream switch is configured properly, yes. Make sure trunking is enabled and your management VLAN is configured for the interface. As long as the AP can connect via L2 and L3 over the wire, it should perform in backhaul mode.