Sir, I have provided the guide to get the AP connected to the HiveManager several times, in this conversation, our direct chat, and our email conversations. Once the AP is connected, and it will show an IP and Hostname once it is connected, then we can configure the device. Until the AP is connected to the HiveManager, you will not be able to configure any SSIDs on it. Once again, I need you to follow this guide to get the APs connected properly to the HiveManager: https://thehivecommunity.aerohive.com/s/article/CAPWAP-Guide-for-HiveManager-NG
Here are some other guides for different configuration set ups, but these are all separate functionalities, which is why I was asking what kind of network you wanted to set up, so I could give you the guide you need instead of all of our SSID configuration guides at once:
PSK-https://thehivecommunity.aerohive.com/s/article/PSK-SSID-How-To-NG
PPSK-https://thehivecommunity.aerohive.com/s/article/PPSK-SSID-in-NG
Radius-https://thehivecommunity.aerohive.com/s/article/Radius-SSID-in-NG
You might also find these guides helpful, being new to HiveManager:
Select GUI overview:https://thehivecommunity.aerohive.com/s/article/HiveManager-Select-GUI-Overview
How to update firmware on APs (6.5r3 or later): https://thehivecommunity.aerohive.com/s/article/Updating-HiveOS-Firmware-in-NG
You can find all of our guides specifically relating to HiveManager here: https://thehivecommunity.aerohive.com/s/topic/0TOa0000000Hj9vGAC/hivemanager-previously-ng?tabset-d9...
If you need more assistance than these guides can provide, you will need to purchase technical support.
