Is it possible to push a complete update when AP is in client mode?

[marco_scano]

Is it possible to push a complete update when AP is in client mode?

[marco_scano]

Hi boy, I've found the issue. With version 8.x everything works fine, with version 10.0r5 there is no way to do a complete update or a firmware update.

Now I'll open a case.

[marco_scano]

The function I need is, as you said, use the WLAN for the backhaul and the LAN to bridge a wired device, but when I push a complete update I loss the backhaul connection, so the upgrade process fails.

I have troubleshooted and seems that when I push a complete update, the wifi interface mode switch from backhaul to wan...

[bruce_stahlin]

This would be expected behavior as the purpose of AP client mode is to use a WLAN connection for backhaul in lieu of the LAN connection. To have backhaul over both would create a loop. The LAN connection may now be used to, say bridge a wired device.

What are you attempting to accomplish?

[marco_scano]

I've just followed these guides, but if I select Client Mode for the interface wifi0, the interface wifi1 is automatically setted in client access mode, without the possibility to set the backhaul mode.