Issue Allowed-vlan auto from HM

[sajid_abbas]

Hi,

We have a CVG on VM which, from the forum, needs to have promiscuous mode enabled. This has been causing some massive traffic spikes form unwanted network traffic causing high CPU usages as well.

I added the command "interface eth0 allowed-vlan auto" on the CLI. When I pushed a delta config to it from HM it revoked that command, reverting to allowed-vlan all.

Does anyone know how can I configure the command to allow Auto vlan on HM so that any config push does not cause to revert it to all vlan.

Thanks

Sajid

[sajid_abbas]

Hi,

So I performed the steps given by enabling the Supplemental CLI option, creating the CLI object and complete push of the policy.

It didn't work as expected.

To test this, it I pushed the following cli command to AP250 which we noticed turn off their LEDs automically.

Config shown in attached capture.

Are these option somewhere in GUI which over writes the CLI config or are they in the wrong format.

[samantha_lynn]

Of course, and thank you for letting me know which HiveManager platform you are using. This guide will walk through how to create a Supplemental CLI object in Classic: https://thehivecommunity.aerohive.com/s/article/How-to-create-a-Supplemental-CLI-in-HiveManager-Clas...

[sajid_abbas]

Just for note, we are on HiveManager Classic version 8.2r2.

[sajid_abbas]

Hi Sam,

Thanks for your response.

Are you able to elaborate how I can create that supplemental CLI object for this or any other command for that matter, that can survive policy push and reboots

Thanks

Sajid

[samantha_lynn]

The HiveManager will overwrite manual settings that conflict with the settings it pushes out from the network configuration build. You could try creating a supplemental CLI object for that auto VLAN command so it won't get overwritten with configuration pushes and/or reboots?