Just want to find out is there a stright forward way that when you have configured wifi bridged on AP230. You able to get into the " Client SSID List" without need to go through Admin login page > Client mode SSID > select SSID > Connect

[tech-lon]

Just want to find out is there a stright forward way that when you have configured wifi bridged on AP230. You able to get into the " Client SSID List" without need to go through Admin login page > Client mode SSID > select SSID > Connect

On the MacOS X, when you initial connected to the AP SSID "Client Mode SSID" will pop up but when you need to change a different SSID then you will required to go through the same process Admin login page > Client mode SSID > select SSID > Connect. Whereas for windows or linux machine, there is no pop-up like what we can see on MacOSx, therefore we will need to Admin login page > Client mode SSID > select SSID > Connect to get connect to another SSID as bridge.

Just wondering is there any simpler way to get to the Client Mode SSID List without needing to go through "Admin login page". An answer will helps a lot

MichaelC

[samantha_lynn]

Thank you for your patience while I looked in to this for you. Unfortunately we aren't able to do that, they would need the admin account.

[tech-lon]

@Sam Pirok​  Thank you for your reply.

My concern is not so much as CLi command. Due to certain circumstances we would like to enable normal user to access the AP that we have setup as wifi bridge to able to access the Client Mode SSID page so that can change the SSID without providing them the admin account that may compromised the setting on the AP.

Ta,

MichaelC

[samantha_lynn]

The only way to see that SSID list would be in the Admin settings, we don't have a CLI command that will generate that list.